【多选题】路由器 A 和路由器 B 通过 S0/0/0 接口直连,路由器 A 输入配置如下: interface S0/0/0 ip address 9.9.23.3 255.255.255.0 ospf authentication-mode simple cipher 1 如果路由器 B 要和路由器 A 形成邻接关系,那么路由器 B 接口 S0/0/0 需要输入什么配置?
【单选题】R1 forwards a packet from Host 1 to remote Server 1. Which statement describes the use of a MAC as the frame carrying this packet leaves the s0/0/0 interface of R1()。
A.
The frame does not have MAC addresses.
B.
The source MAC address in the frame is the MAC address of the NIC of Host 1.
C.
The source MAC address in the frame is the MAC address of the s0/0/0 interface of R1.
D.
The destination MAC address in the frame is the MAC address of the NICof server 1.
E.
The destination MAC address in the frame is the MAC address of the s0/0/0 interface of R2
【多选题】Examine the following configuration on Router R1. R1's show ip route 172.16.4.1 command list s a route with outgoing interface S0/1/1. Host 172.16.3.3 uses telnet to connect to host 172.16.4.1.What wi...
A.
The packet will be forwarded out S0/0 /1, or not at all.
B.
The packet will be forwarded out S0/0/1 if it is up.
C.
The packet will be forwarded out S0/1/1 if it is up.
D.
The packet will be forwarded out S0/1/1 if it is up, or if it is not up, out s0/0/1.
E.
The packet will be forwarded o ut S0/0/1 if it is up, or if it is not up, out s0/1/1.
【单选题】Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the ...
A.
Telnet to WANRouter and execute the command show interfaces S0/0
B.
Telnet to WANRouter and execute the commandshow processes S0/0
C.
Telnet to WANRouter and execute the command show running-configuration
D.
Telnet to WANRouter and execute the command show controller S0/0
E.
Physically examine the cable between WANRouter S0/0 and the DCE.
F.
Establish a console sessionon WANRouter and execute the command show interfaces S0/0
【单选题】The network administrator is in a campus building distant from Building B. WANRouter is hosting a newly installed WAN link on interface S0/0. The new link is not functioning and the administrator need...
A.
Telnet to WANRouter and execute the command show interfaces S0/0
B.
Telnet to WANRouter and execute the command show processes S0/0
C.
Telnet to WANRouter and execute the command show running-configuration
D.
Telnet to WANRouter and execute the command show controller S0/0
E.
Physically examine the cable between WANRouter S0/0 and the DCE
F.
Establish a console session on WANRouter and execute the command show interfaces S0/0